The PRO's do the following to your BAD Series Brakes to install them on your PRObuilt Beam;
- Drive bearing races into your hubs and seat them properly
- Pack bearings correctly and install them into the hubs
- Install seal correctly and lube the v-groove
- Install caliper brackets with kit's hardware using loctite to securely fasten the hardware
- Lube the spindle shafts
- Install BAD Series Rotor Assemblies onto spindle shaft
- Supply bearing thrust washers and install
- Supply spindle nuts and loctabs and tighten to have correct thrust on the bearings
- Securely faster dust cap including adding anti-seize on hardware and tightening hardware
- Calculating spacers needed to properly center the calipers on the rotors, using the supplied hardware and loctite to ensure proper specifications
- Load calipers with pads and secure properly
Brakes onto Link Pin 
